6.5.12 Removing/Replacing the Fan Assembly
To remove and replace the fan assembly, perform the following procedure:
1.
Remove the Top Cover Assembly as described in Paragraph 6.5.10.
2.
Remove the two screws that secure the cover plate to the FIR/Audio Board.
3.
Remove the two screws holding the fan assembly in place and unplug the fan cable connector
J6 from the FIR/Audio Board (refer to Figure 6-17).
4.
Remove the Fan Assembly.
5. Replacement is the reverse of Steps 1 through 4.
LED Board Cable
Battery Board Cable
Battery Board
Figure 6-17
Internal Assemblies, Removal/Replacement
Service Guide
CN1
J17
FIR/Audio Cover
LED Board Assembly
Fan Assembly
Fan Connector J6
6-15