6.5.13 Removing/Replacing the LED Board
1.
Remove the Top Cover Assembly as described in Paragraph 6.5.10.
2.
Disconnect the LED cable from the Main Board (refer to Figure 6-17).
3.
Remove the LED Board Assembly.
4.
Replacement is the reverse of Steps 1 through 3.
6.5.14 Removing/Replacing Inside Frame Assy
Use the following procedure to separate the inside frame assembly from the base assembly:
1.
Remove the Top Cover as described in Paragraphs 6.5.10.
2. Separate the inside frame assembly from the base assembly as shown in Figure 6-18.
Figure 6-18
Removing/Replacing the Inside Frame Assembly
6-16
Remove three screws that secure
the inside frame assembly to the
base assembly.
Separate
the
inside
assembly
from
assembly
Field Service
frame
the
base