Table of Contents
Advertisement
4076-0WJ
•
Be extra careful in working with ESD-sensitive parts when cold-
weather heating is used because low humidity increases static
electricity.
Adjustments
Bi-directional Alignment Adjustment
The bi-directional alignment can be checked by printing a test page.
The adjustment is correct when the vertical bars appear straight. To
adjust the bi-directional alignment:
1. Attach the printer to a PC operating in DOS.
2. Load paper in the Auto Sheet Feed.
3. Place the 4076 OWJ Service Diskette in the diskette drive. Type
the letter of the drive, colon, and adjust. For example; a:adjust.
4. A page loads and the bi-directional alignment pattern prints. The
pattern consists of three lines of vertical bars. The bars are
aligned when the adjustment is correct. The following sample
requires the center vertical bars to be moved to the right.
5. Follow the directions on the menu and move the center bar to
line up with the other two bars. Each time a selection is made,
the pattern will print.
6. When the alignment is correct, toggle over to the draft mode.
Follow the same procedure as above to align the bars in the draft
mode.
7. When you complete the adjustment and turn off the printer the
settings will be saved in the printer.
Repair Information
22
Advertisement
Table of Contents
