Connect To End Node - D-Link 1016T - DGS Switch User Manual

Connect to End Node

End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ-45
Ethernet/Fast Ethernet Net work Interface Card (NIC) and Ethernet ready
routers. Use standard Ethernet cable to connect the Switch to end nodes.
Switch ports will auto matically adjust to the hardware characteristics
(MDI-II/MDI-X, speed, duplex) of the device to which it is connected.
Observe the guidelines for cable quality stated at the beginning of th is section.
The Link/Act LEDs fo r each port lights green when the link is valid.
Switch connected to an end node
26