Basic Operations - Jabra BT250 - Headset - Over-the-ear User Manual

WARNING: Do not attempt to charge Jabra BT250 with anything other than the AC
adaptor provided. Using another AC adaptor may damage or destroy the headset.
IMPORTANT: The blue indicator light will be on while charging and will turn off
when charging is complete. Removing the headset from the charging cradle while it's
charging will put the headset into standby mode and stop the charging sequence.
IMPORTANT: Jabra BT250 cannot be used while charging.
3
Read the glossary
Read the glossary at the end of this document to familiarize yourself with important
terms used in this User Manual.
Once Jabra BT250 is fully charged, continue with these instructions.
4
"Pair" to your Bluetooth phone
3
Pairing will create a unique and encrypted wireless link between two Bluetooth
enabled devices such as your Bluetooth phone and Jabra BT250.
1. Ensure the headset is off (see Turning headset
on/off section).
2. Press and hold until you see a solid blue light
(approximately 8 seconds), then release*
(see Fig. 2).
3. Set your Bluetooth phone to "discover" the
headset by following your phone's instruction
guide. Typically, the steps involve going to a "setup",
"connect", or "Bluetooth" menu on your phone and
then selecting the option to "discover" a Bluetooth
device.
4. Your phone will find the "Jabra BT250" headset and ask
if you want to pair with it. Confirm this by pressing "yes" or "ok".
4
5. Enter passkey or PIN = 0000 (4 zeros), then press "yes" or "ok".
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing every 3 seconds. If unsuccessful, the light remains solid,
and you'll need to reattempt pairing (see steps 3–5 above).
4
* If you have a Bluetooth phone that supports the hands-free Bluetooth profile,
see Enhanced features section for alternative pairing instructions. Phone-
specific pairing instructions can be found online at www.jabra.com/fscs

BASIC OPERATIONS

5
Turning headset on/off
Turning
headset on
Turning
headset off
Status indicators
What you see
Flashes every
Fig. 2
second
Flashes every
3 seconds
Fig. 3
3 flashes every
second
3 flashes every
3 seconds
*
Depending on phone type and usage.
What you do What you hear
Press and hold for 3 to Ascending
5 seconds until you see a (low-to-high)
burst of flashes on the blue tones
indicator light, then release
Press and hold for 3 to Descending
5 seconds until you see a (high-to-low)
burst of flashes on the blue tones
indicator light, then release
What you hear Status
Quick series of 2 tones Active Mode
•
– low to high pitch (when
•
active mode starts)
Quick series of 2 tones Standby Mode
•
– high to low pitch (when
•
standby mode starts)
Low Battery (in active mode)
3 beeps every 30 seconds
•
3 beeps every 5 minutes Low Battery (in standby mode)
•
What you see
The blue indicator
light will flash while
the power is on (see
Status indicators
table below)
The blue indicator
light will stop
flashing
5
Call in progress
Up to 8 hours of talk-time*
6
Waiting for call
Up to 240 hours of
standby time*
3 – 5 minutes of talk time left
3 – 5 minutes of talk time left
5