Configuring X-On/X-Off Protocol - Alcatel-Lucent OmniSwitch 6600 Family Hardware User's Manual

OmniSwitch 6600 Family Chassis and Hardware Components

Configuring X-ON/X-OFF Protocol

By default, X-ON/X-OFF protocol is enabled on the console port. To enable and disable the X-ON/X-OFF
protocol on a console port that you are logged into use the
xon-xoff followed by either enable or disable.
For example, to disable X-ON/X-OFF on a console port enter:
-> session xon-xoff disable
Note. To enable or disable the X-ON/X-OFF protocol on secondary or idle switches in a stack you must
log into those switches and then execute the session xon-xoff command.
OmniSwitch 6600 Family Hardware Users Guide
session xon-xoff
September 2006
Console Port
command by entering session
page 2-64