Replacing Toner Container - Kyocera KM-F1060 Operating Instructions Manual

Problem Solving

Replacing Toner Container

Low Toner message will follow this progression:
(Order the Toner Container using the Order Form (See Note below).
Replace the Toner Container before the Toner runs out)
TONER IS RUNNING LOW
WARNING!! TONER LOW
LESS THAN 50 PAGES
OUT OF TONER
NOTE:
When ordering the Toner Container, print the Order Form using the
following procedures, and Fax it to your Authorized dealer.
Press
FUNCTION
FUNCTION
ENTER NO. OR
Press
3:TONER ORDER FORM?
PRESS SET TO PRINT
Press
SET
If "2:NO" is selected in Step 12 on page 29:
1
28
Getting To Know Your Machine
Operation Chart
Toner is Low*.
Machine can make less than 500 prints**.
U13
Toner is Nearly Empty.
Machine can make less than 50 prints*.
Toner is Empty.
Machine stops.
U13
* Shake the toner container well, or this
message may display.
** Based on 5% print coverage.
(See page 12)
on the Panel.
(1-9)
∨ ∧
.
7 8 3
SET
to print the Order Form.
2
FUNCTION
ENTER NO. OR
(Operate with the Power Switch in "ON"
position)
1
5
CAUTION
Be careful not to scratch the surface of
the OPC Drum (Green), and not to touch
it with bare hands. The OPC Drum is
sensitive to light.
To prevent optical exposure problems,
do not expose the OPC Drum to direct
sunlight or bright light.
9
Place the Toner Container over the
Guide Rails and insert it until it stops.
3
(1-9) MAINTENANCE (3-6)
∨ ∧
ENTER NO. OR
Front Cover
REMOVE
Protective Sheet
Toner Container (New)
Guide Rails
∨ ∧