Gpi - Panasonic BT-LH1850 Operating Instructions Manual

Main menu
(continued)
„ FOCUS-IN-RED
„
FOCUS-IN-RED shows the outline of a subject that is in focus in red to simplify focusing the camera.
Each press of the button ("FUNCTION1" to "FUNCTION5") to which the FOCUS-IN-RED has been assigned turns the function on
and off.
• To use the FOCUS-IN-RED function, it must be assigned to one of the "FUNCTION1" to "FUNCTION5" functions.
When the FOCUS-IN-RED function is displayed, use the rotary knob to change detection sensitivity level (0 - 30). A higher numerical
value results in higher detection sensitivity (outlines are displayed in red even when they are not properly focused).
If you set CHROMA to 0 or assign "MONO" to another function button to switch to monochrome, the focus will become easier to check.
The foreground is
in focus
The background is
in focus

GPI

"GPI CONTROL" is used to enable and disable GPI functions and assign functions to each of the GPI input terminal pins (→page 44)
Sub menu
GPI CONTROL DISABLE
ENABLE
GPI1 - GPI8 UNDEF
MARKER1 ON/OFF
MARKER2 ON/OFF
MARKER BACK HALF
MARKER BACK BLACK
CENTER MARKER
CROSS MARKER
INPUT SEL. VIDEO
INPUT SEL. SDI1
INPUT SEL. SDI2
INPUT SEL. HDMI
INPUT SEL. DVI-I
INPUT SEL. INT SG
SD ASPECT
SCAN
R-TALLY
G-TALLY
MONO
GAMMA SEL. FILM
GAMMA SEL. STDIO/PST
PIXEL TO PIXEL
FOCUS-IN-RED
REMOTE STANDBY
<Note>
• Operation may not be possible depending on the setting conditions.
Example: "SD ASPECT" operation when input signal is HD
Push once the FUNCTION button to which
the FOCUS-IN-RED function is assigned.
Normal screen
button again
button again
Settings
Enables and disables GPI functions
<DISABLE>
Assigns functions to the GPI input terminal pins.
The same items can be set to each terminal (→page 44).
FOCUS-IN-RED display
Press the
The outlines in focus are displayed in red
Press the
These examples show 16:9 aspect ratio images.
The underlined values are factory preset setting values.
Description
Disabled <ENABLE> Enabled
37