Optional Siriusxm Tuner Connection; Installation; Installation Using The Screw Holes On The Side Of The Unit - Pioneer AVH-X8500BHS Owner's Manual

Connection
Installing the HDMI cable holder
% Position the HDMI cable holder to insert
its two lower tabs into the groove of this
product, and then tighten the screw (3 mm ×
5 mm) to fix the HDMI cable holder.
2
1
3
3
4
1 HDMI cable holder
2 Screw (3 mm × 5 mm)
3 Tab
4 Groove
! Use the HDMI cable holder when you con-
nect this product with the separately sold
App Connectivity Kit (CD-IH202/CD-AH200).
! Never grip the holder tightly or use force
when removing or attaching.
Optional SiriusXM Tuner
connection
This product
SiriusXM BUS input
SiriusXM BUS cable
(Supplied with SiriusXM tuner)
SiriusXM tuner
(sold separately)

Installation

Notes
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
! Do not install this unit where:
it may interfere with operation of the vehicle.
it may cause injury to a passenger as a result
of a sudden stop.
! The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of less than 30°.
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are not block-
ing the vents.
Leave ample
5 cm
space
5 cm
5cm cm
! To some types of vehicles, this unit cannot be
properly installed. In such case, use the op-
tional installation kit (ADT-VA133).
Installation using the screw
holes on the side of the unit
% Fastening the unit to the factory radio-
mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket, and
tighten the screws at three locations on each
side.
1
2
3
4
1 If the pawl gets in the way, bend it down.
2 Factory radio mounting bracket
3 Use either truss (5 mm × 8 mm) or flush sur-
face (5 mm × 9 mm) screws, depending on
the bracket screw holes.
4 Dashboard or console
Section
24
25
53
En