Dynamic (Cable) - D-Link DIR-140L User Manual

Broadband cloud vpn router

Hide thumbs Also See for DIR-140L:

Table of Contents

Section 3 - Configuration

My Internet

Select Dynamic. IP. (DHCP) to obtain IP Address information

Connection Is:

automatically from your ISP. Select this option if your ISP does not give

you any IP numbers to use. This option is commonly used for cable

modem services.

Host Name:

The Host Name is optional but may be required by some ISPs. Leave

blank if you are not sure.

Primary/Secondary

Enter the Primary and secondary DNS server IP addresses assigned by

DNS Server:

your ISP. These addresses are usually obtained automatically from your

ISP. Leave at 0.0.0.0 if you did not specifically receive these from your ISP.

MTU:

Maximum Transmission Unit - you may need to change the MTU for

optimal performance with your specific ISP. 1500 is the default MTU.

MAC Address:

The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not recommended

that you change the default MAC address unless required by your ISP. You can use the Copy.your.PC's.MAC.Address button to

replace the Internet port's MAC address with the MAC address of your Ethernet card.

D-Link DIR-140L User Manual

Dynamic (Cable)

Table of Contents