Table of Contents
Advertisement
Maintenance
The following sections provide maintenance information and
1
troubleshooting advice.
Troubleshooting
2
1. I have gone through the association procedure, but
still cannot connect to the Hub.
3
Check that the power supply is connected and that the blue
LED on the Hub is lit.
4
If you are sure there is power to the Hub, open the Wireless
USB Manager. On the opening screen, your Hub should be
5
one of the devices listed. If it is not, perform the cable- or
PIN-association procedure again.
6
If you see your device listed, make sure there are two green
arrows pointing to each other over the device icon. If the
software does not show a wireless connection, move your
Hub closer to the computer to see if that fixes the problem.
If neither of those steps work, try resetting your Hub by
unplugging the power-supply connector from the back of
the Hub, waiting a few moments, and then plugging it back
in. Note: After doing this, you must repeat the security-
association setup.
16
Advertisement
Table of Contents
