HP StorageWorks 600 - Modular Disk System Maintenance And Service Manual page 37

Hp storageworks 600 modular disk system maintenance and service guide

Hide thumbs Also See for StorageWorks 600 - Modular Disk System:

Table of Contents

Push in to release the four locking mechanisms on the rails located on the side and bottom of the

13.

drawer.

Remove the hard drive drawer.

14.

To replace the component:

Slide the rails back into the chassis.

Align the top right edge of the drawer with the flange at the top of the chassis and align the four

rails on the left side and bottom of the drawer bay.

CAUTION:

To avoid damage to the equipment, HP recommends using two people to perform

this step.

Removal and replacement procedures 37

Table of Contents