Hi-Speed Usb 2.0 Support; Ata Support; Pata Interface - Intel DP43BF Product Manual

Hi-Speed USB 2.0 Support

The Desktop Board supports up to 12 USB 2.0 ports (six ports routed to the back
panel and six ports routed to three internal headers) via ICH10. USB 2.0 ports are
backward compatible with USB 1.1 devices. USB 1.1 devices will function normally at
USB 1.1 speeds.
USB 2.0 support requires both an operating system and drivers that fully support
USB 2.0 transfer rates. Disabling Hi-Speed USB in the BIOS reverts all USB 2.0 ports
to USB 1.1 operation. This may be required to accommodate operating systems that
do not support USB 2.0.

ATA Support

The board includes six ATA interface connectors:
• One PATA connector that supports two devices
• Five SATA connectors that support one device each

PATA Interface

The board's discrete PATA controller provides one bus-mastering PATA interface that is
accessible through a standard PATA (IDE) connector. The PATA interface supports the
following modes:
• Programmed I/O (PIO): the processor controls data transfer.
• 8237-style DMA: DMA offloads the processor, supporting transfer rates of up to
16 MB/s.
• Ultra DMA: DMA protocol on the ATA bus supporting host and target throttling and
transfer rates of up to 33 MB/s.
• ATA-66: DMA protocol on the ATA bus supporting host and target throttling and
transfer rates of up to 66 MB/s. ATA-66 protocol is similar to Ultra DMA and is
device driver compatible.
• ATA-100: DMA protocol on the ATA bus allows host and target throttling.
NOTE
ATA-66 and ATA-100 are faster timings and require a specialized cable to reduce
reflections, noise, and inductive coupling.
The PATA interface also supports ATAPI devices (such as CD-ROM drives) and ATA
devices using the transfer modes.
The BIOS supports Logical Block Addressing (LBA) and Extended Cylinder Head Sector
(ECHS) translation modes. The drive reports the transfer rate and translation mode to
the BIOS.
Desktop Board Features
19