Ai Net 2; Asus Ez Flash 2 - Asus SABERTOOTH 55i - Motherboard - ATX User Manual

Update To Normal Mode [Press Enter]
Allows you to use the SATA_E1 (orange) and SATA_E2 (white) connectors as normal
SATA connectors.
When using only one hard disk in Normal Mode, connect the hard disk to the SATA_E1
(orange) connector on the motherboard.
Create Ultra Space [Press Enter]
This item appears only when you created a Super Speed or a EZ Backup set using
two hard drives with different capacity and allows you to create a single drive
partition using all the drive space unused by Drive Xpert.
Delete Ultra Space [Press Enter]
This item appears only when you have created a drive partition using the Ultra Space
function. All data stored in the Ultra Space partition will be erased.
Drive Xpert Device(s) List:
SATA_E1 (Orange) / SATA_E2 (White)
Press <Enter> to display the information of the hard disks which are connected to the
SATA_E1 (orange) and SATA_E2 (white) connectors on the motherboard.
3.9.3

AI NET 2

AI NET 2
Pair Status Length
Check Realtek LAN cable
Check Realtek LAN cable [Disabled]
[Disabled] BIOS will not check the Realtek LAN cable during the Power-On Self-Test
(POST).
[Enabled] BIOS checks the Realtek LAN cable during the Power-On Self-Test (POST).
3.9.4

ASUS EZ Flash 2

Allows you to run ASUS EZ Flash 2. When you press <Enter>, a confirmation message
appears. Use the left/right arrow key to select between [Yes] or [No], then press <Enter> to
confirm your choice.
For more details, refer to section 3.2.2 ASUS EZ Flash 2 utility.
ASUS SABERTOOTH 55i
BIOS SETUP UTILITY
[Disabled]
Tools
3-37