Lenovo ThinkCentre A35 Service Manual page 50

2.Disabled: Disable USB Controller.
6-4 Power Management Setup
ACPI Suspend Type
1.S1(POS) : Set ACPI suspend type to S1/POS (Power On Suspend). (Default value)
2.S3(STR) : Set ACPI suspend type to S3/STR (Suspend To RAM).
Soft-Off by PWR-BTTN
1.Off: Press power button to turn off the system instantly. (Default value)
2.Suspend: Press power button for 4 seconds to turn off the system. The system will enter
suspend mode if the button is pressed for less than 4 seconds.
System After AC Back
1.Off: When AC-power is back to the system, the system will be in "Off" state.
(Default value)
2.On: When AC-power is back to the system, the system will be always in "On" state.
3.Laststate : When AC-power is back to the system, the system will return to the last state
before AC-power was off.
IRQ [3-7, 9-15], NMI
When IRQ [3-7, 9-15] or NMI triggered, the suspend timer will be reloaded to prevent system
from getting into green mode.
1.Disabled: Don' t monitor IRQ [3-7, 9-15] or NMI.
2.Enabled: Monitor IRQ [3-7, 9-15] or NMI.(Default value)
Modem Ring On
1.Disabled: Disable Modem Ring On function.
2.Enabled: Enable Modem Ring On function.(Default value)
PME Event Wake Up
49