Lenovo ThinkCentre A35 Service Manual page 48

Boot Other Device
1. Enabled: Enable to boot from other device.(Default value)
2. Disabled: Disable to boot from other device.
English
Boot Up Floppy Seek
During POST, BIOS will determine if the installed floppy disk drive is 40 or 80 tracks. 360K
type is 40 tracks 720K, 1.2M and 1.44M are all 80 tracks.
1. Disabled: BIOS will not search for the type of floppy disk drive by track number. Note
that there will not be any warning message if the drive installed is 360K.
(Default value)
2. Enabled: BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks. Note
that BIOS can not tell from 720K, 1.2M or 1.44M drive type as they are all 80
tracks.
Password Check
1. Setup: The system will boot but will not access to Setup page if the correct
password is not entered at the prompt. (Default value)
2. System: The system will not boot and will not access to Setup page if the correct
password is not entered at the prompt.
If you want to cancel the setting of password, please just press ENTER to make [SETUP]
empty.
CPU Hyper-Threading
This option appears only when the processor you install supports Intel® Hyper-Threading
Technology.
1. Enabled Enable CPU Hyper-Threading feature. Please note that this feature only
works for operating system with multiprocessors mode supported. (Default
value)
2. Disabled Disable CPU Hyper-Threading.
Limit CPUID Max. to 3
This option is available only when you install an Intel® Prescott processor
1. Enabled Limit CPUID Maximum value to 3 when using older OS like NT4. (Defaults
value)
2. Disabled Disable CPUID Limit for Windows XP.
Full Screen LOGO Show
1. Enabled Display Full Screen LOGO during POST. (Default value)
2. Disabled Do not display Full Screen LOGO during POST.
Intel OnScreen Branding
1. Enabled Show Intel OnScreen Branding. (Default value)
2. Disabled Do not display Intel brand LOGO.
Flexible AGP 8X
1. Auto Automatically set AGP transfer rate according to the compability and statility
of the AGP graphics card.(Default value)
2. 4x Set AGP transfer rate to 4x mode no matter what the AGP transfer rate the
card has.
Init Display First
Select the first initiation of the monitor display from AGP or PCI VGA card.
1. PCI Set Init Display First to PCI VGA card.
47