Remote Control - RCA RV-3798 User Manual

Tour of the Receiver

Remote Control

Your remote control is capable of operating most RCA audio
and video equipment. To use the remote control effectively,
always aim it directly at your receiver.
The remote control operates on four batteries, included with
your system. Install them before attempting to operate the
remote. Be sure to match the
the symbols shown in the remote's battery compartment.
Basic Controls
POWER Turns the AM/FM receiver off with one press. If you
have multiple components turned on and not the AM/FM
receiver, pressing POWER once turns off the last component
turned on. Pressing POWER again quickly turns off all other
components.
VOL UP and DOWN Increases or decreases the volume.
MUTE Turns off the receiver's sound. Press again to restore
the sound.
Receiver Controls
AM•FM Activates the tuner and toggles between the AM
band and the FM band.
CTR MODE Changes the Center mode when using Dolby
Pro-Logic Surround or Dolby 3 Stereo surround modes. Press
once and the current mode appears. Press again to change
the mode.
DELAY/CH CTRL Selects the amount of Surround Sound delay
between the main and rear speakers. Choose from 15, 20 or
30 milliseconds. Press once and the current setting appears.
Press again to change the setting.
SURROUND Lets you select a Surround Mode: Dolby
Pro Logic Surround, Dolby 3-Stereo, Hall or By-Pass. Press once
and the current mode appears. Press again to change the
mode.
SWAP AUDIO Swaps the audio only from the large picture to
the small picture when you are watching TV and using
picture-in-picture (PIP).
18
-
+
and ends of each battery to
S
TAPE CD
AM•FM
REV PLAY
FWD
REC STOP PAUSE
GUIDE•RDM SKIP
ENTER
MUTE GO BACK•DISC
1 2 3
4 5 6
7 8 9
INPUT•SEEK ANTENNA
0
INFO CLEAR RESET•REP DELAY
CH CTRL
MENU TV MENU
MOVE
SELECT
+
–
PIP SWAP PIP
CTR MODE
PLAYLIST
•
BY-PASS LEVEL
SWAP
AUDIO