Wyse R50L Installation Manual page 11

Converting Wyse R Class to ThinOS
10.Select the USB key onto which you want the configurations (you can use Refresh as
needed to recognize an inserted USB key), and then click Next. The progress bars
show the overall (formatting and configuration) progress and task progress.
11. After configuration, click Finish to close the wizard and then remove the configured
USB key for use (you will use the configured USB key on your target devices).
Caution
Before using any configured USB key on a target device (to push firmware),
you must configure the target device to boot from the configured USB key as
described in "Step 4: Use the Configured USB Key to Install Firmware on
Each Thin Client."
Step 4: Use the Configured USB Key to Install Firmware on Each Thin Client
On each thin client you want to convert, use the one-time boot menu to configure it to boot
from the configured USB key (the one-time boot menu will not modify your default BIOS
configurations).
To enter and use the one-time boot menu:
1. Attach the configured USB key to the thin client (be sure it is shut down and
disconnected from any network).
2. Power on the device while pressing and holding the P key during boot. When prompted
for a boot option, select the USB HDD option for your device (usually option 3 in the list
of boot options) and press Enter.
3. Follow the process prompts.
Tip
When booting a target device from the configured USB key (containing the
contents to be pushed to a target device), you will be prompted to continue
with the push process (to continue, type y and press Enter). Once the push
process is complete, you will be prompted to reboot (to reboot, press Enter
and remove the USB key).
Caution
During the Critical Operation in Progress message, do not interrupt the
process.
Step 5: Verifying Thin Client Operation
After the thin client reboots, you can verify that your general client information is correct.
1. After your thin client reboots, the System Information dialog box appears on the
desktop.
2. On the General tab of the System Information dialog box, verify the following:
• System Version is 7.0.0_30.
3. Click OK to close the System Information dialog box. The thin client is ready for
operation and setup by an administrator.
Tip
For more information, see Administrators Guide: Wyse ThinOS™.
Administrator and other documentation for your thin client model are
available at: http://www.wyse.com/manuals.
7