Formatting The Sd Memory Card - Sanyo WXU30 - PLC - LCD Projector Owner's Manual

* The data converted by the Network Viewer 4 [File Converter1] can be stored into the SD memory card
mounted on the projector directly. For further information, refer to chapter Network Viewer function,
"Setting of output destination and conversion mode" (p.113) described on the separated booklet of
Network Owner's manual.
* The program file created by the Program Editor can be stored into the SD memory card mounted on
the projector directly. For further information, refer to chapter Network Viewer function, "Creating the
program file" (p.115) described on the separated booklet of Network Owner's manual.

Formatting the SD memory card

A new SD memory card or a card formatted by computer or camera must be formatted by this product.
Memory Viewer function may not operate properly with a card formatted by other equipment.
* It cannot be formatted when the lock switch of the card is set to "LOCK" position.
1. In the memory viewer mode, press AUTO SETUP/CANCEL button. The browser window appears on
the screen.
2. Press AUTO SETUP/CANCEL button again. The cursor moves to menu item.
3. Select "Format" from "Menu" with the point buttons and press SELECT button. The format
confirmation window appears.
4. Select "Yes" with the point buttons and press SELECT button to start formatting. It takes about 1-2
seconds to complete the formatting.
Note:
✐ During formatting the SD memory card, do not turn off the power or eject the card because the data
in the card might get damaged. During formatting, the SD memory card indicator is blinking.
11