Brocade Communications Systems SN3000B Command Reference Manual page 645

EXAMPLES
To create a FICON-enabled tunnel, first create an empty FCIP tunnel without any circuits:
To enable FICON and compression on the tunnel (this sets the keepalive timeout value to 1000 ms,
which is the default for DFICON-enabled tunnels):
To create two circuits (circuit 0 and circuit 1) on the tunnel (these circuits will be created with the
FICON-compatible keepalive timeout value):
To display circuit 1:
Fabric OS Command Reference
53-1001764-01
Valid options and arguments for mgmtroute include the following:
create
Creates a management route for a specified destination IP Address. The following
operands are required:
dest_IPv4_addr
Specifies the destination IP address for the management route in IPv4
format.
netmask
Specifies the subnet mask for the IPv4 address in a.b.c.d format.
gateway
Specifies the IP address of an IP router that can route packets to the
destination IP address.
delete
Deletes a management route for a specified destination IP Address. The following
operands are required.
dest_IPv4_addr
Specifies the destination IP address for the management route in IPv4
format.
netmask
Specifies the subnet mask for the IPv4 address in a.b.c.d format.
switch:admin> portcfg fciptunnel 1/12 create
Operation succeeded
switch:admin> portcfg fciptunnel 1/12 modify -c 1 -F 1
Operation succeeded
switch:admin> portcfg fcipcircuit 1/12 create \
0 192.168.51.61 192.168.50.68 -b 300000 -B 500000
Operation succeeded
switch:admin> portcfg fcipcircuit 1/12 create
1 192.168.50.61 192.168.51.68 -b 300000 -B 500000
Operation succeeded
switch:admin> portshow fcipcircuit 1/12 1
-------------------------------------------
Circuit ID: 1/12.1
Circuit Num: 1
Admin Status: Enabled
Oper Status: In Progress
Remote IP: 192.168.51.61
Local IP: 192.168.51.68
Metric: 0
Min Comm Rt: 300000
Max Comm Rt: 500000
2
portCfg
619