Security Consistency Checklist - HP StorageWorks SN6000 User Manual

configuration that was displayed is the configuration that is applied to all other switches in the stack. The
following operations are available to configure the stack as a single entity.
Under Stack menu:
• Date/time and NTP settings. For more information, see
client" (page 58).
• Firmware load and activation. For more information, see
• Switch reset. For more information, see
• Editing user accounts. For more information, see
• SNMP configuration. For more information, see
• Security Consistency Checklist. For more information, see
• Syslog configuration. For more information, see "Syslog" (page 61).
Additional stack operations include the following:
• Move the selected switch up or down one position in the stack within the graphic window. To move a
switch image up, select a switch, open the Stack menu, and select Move Switch Up. To move a switch
image down, select a switch, open the Stack menu, and select Move Switch Down.
• Remove a switch from being associated with the stack if the switch is not connected to any other switch
in the fabric with an ISL connection. To remove a switch from a stack, select a switch, open the Stack
menu, and select Remove Switch.
Remove a dead ISL connection in the stack display between two switches that is either offline or has
•
been physically disconnected. To remove a dead link (red), select one of the linked XPAK ports, open
the Stack menu, and select Remove Links.
• Refresh the stack to update the faceplate display with current information for all switches in the stack
• Select all ports on all switches in the stack.
Under Zoning menu:
• Edit Zoning. For more information see
• Edit Zoning Config. For more information see
• Activate Zoning. For more information see
• Deactivate Zoning. For more information see

Security Consistency Checklist

The Security Consistency Checklist dialog box
settings, such as, firmware versions, embedded GUI, in-band management, date/time on switches. Any
changes must be made through the appropriate dialog, such as Network Properties dialog, Switch
HP StorageWorks SN6000 Fibre Channel Switch QuickTools Switch Management User Guide
"Setting the date/time and enabling NTP
"Installing
"Resetting a switch" (page 59).
""Managing user
"SNMP configuration" (page 69).
"Security Consistency
"Editing the zoning database" (page 36).
"Configuring the zoning
"Activating and deactivating a zone
"Activating and deactivating a zone
(Figure 23) enables you to view current security-related
firmware" (page 79).
accounts" (page 55).
Checklist" (page 53).
database" (page 39).
set" (page 41).
set" (page 41).
53