Inserting The Batteries In The Remote Control; Assembling The Stand-Base - Samsung PPM42M7HB - 42" Plasma Panel Owner's Instructions Manual

BN68-01304A-00Eng 5/31/07

Inserting the Batteries in the Remote Control

You must insert or replace the batteries in the remote control when
you:
◆ Purchase the PDP Display
◆ Find that the remote control is no longer operating
correctly
1
Remove the cover on the rear of the remote control by pressing
the symbol (
2
Insert two R03, UM4, "AAA" 1.5V or equivalent batteries taking
care to respect the polarities:
◆
- on the battery against - on the remote control
◆
+ on the battery against + on the remote control
3
Replace the cover by aligning it with the base of the remote
control and pressing it back into place.
Do not mix battery types, i.e. alkaline and manganese.

Assembling the Stand-Base

1
Assemble the PDP Display with the stand and firmly
secure the PDP Display using 4 screws provided.
➢
Two or more people should carry the PDP Display.
Never lay the PDP Display on the floor because of
possible damage to the screen.
Always store the PDP Display upright.
3:49 PM Page 9
) downwards and then pulling firmly to remove it.
English - 9