2.
Primary/Secondary IDE connectors (40-1 pin PRI_IDE [blue]; 40-1 pin
SEC_IDE [black])
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device(s).
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
P5VD2-X
®
P5VD2-X IDE connectors
ASUS P5VD2-X
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
PIN 1
Mode of
Cable connector
device(s)
-
Black
Black
Master
Slave
Gray
Master
Black or gray
Slave
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
1-29