Asus P5SD2-X - Motherboard - ATX Installation Manual page 106

Repairing a Mirror conflict
A Mirror conflict occurs when one or both disks in a RAID 1 (Mirror) configuration
are unplugged from the system, then plugged in again. Since both disks contain
exactly the same data, the system will be unable to determine which of the two
is the source drive. This option allows you to set the source drive and rebuild the
Mirror drive according to the contents of the source drive.
To repair a Mirror conflict:
1. In the main JMB363 RAID BIOS menu, highlight Repair Mirror Conflict using
the up/down arrow key then press <Enter>.
2. Use the space bar to select the HDD that you want to set as source drive.
The selected HDD shows a
3. Using the <TAB>, move to the RAID Disk Drive List menu and highlight the
RAID set that you want to rebuild. Press <Del> to begin rebuilding the Mirror
configuration.
A status bar at the bottom of the screen shows the progress of the rebuilding.
JMicron Technology Corp. PCI-to-SATA II/IDE RAID Controller BIOS v0.97
[Main Menu]
Create RAID Disk Drive
Delete RAID Disk Drive
Revert HDD to Non-RAID
Repair Mirror Conflict
Save and Exit Setup
Exit Without Saving
[RAID Disk Drive List]
RDD0: JRAID
3-18
[Main Menu]
Create RAID Disk Drive
Delete RAID Disk Drive
Revert HDD to Non-RAID
Repair Mirror
Save and Exit Setup
Exit Without Saving
sign before it.
[Hard Disk Drive List]
HDD0: HDS722516VLSA80 164 GB
HDD1: HDS722516DLA380 164 GB
Model Name RAID Level
1-Mirror
Rebuilding... 01%, please wait...
Conflict
Model Name Capacity
Capacity Status
XXX GB Rebuild
Chapter 3: Software support
Type/Status
RAID Inside
RAID Inside
Members(HDDx)
01