Table of Contents
Advertisement
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a paper clip or thin object. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. It takes
about 30 seconds. Note that all settings will be restored to factory default. Upon successful
restore, the status LED will blink green and red during normal operation.
SD/SDHC Card Capacity
This network camera is compliant with SD/SDHC 16GB / 8GB and other preceding standard SD
cards.
Installation
Hardware Installation
Follow the steps below to
1. Mount the lens by turning it clockwise onto the camera mount until it stops. If necessary, turn
the lens counterclockwise slowly until it gets the best attitude.
2. Connect the lens cable plug to the camera connector.
Network Deployment
Setting up the Network Camera over the Internet
This section explains how to configure the Network Camera to an Internet
1. If you have external devices such as sensors and alarms, connect them to the general I/O
terminal block.
2. Connect the camera to a switch via Ethernet cable.
3. Connect the power cable from the Network Camera to a power outlet.
There are several ways to set up the Network Camera over the
up the Network Camera behind a
to use
PPPoE.
There are several ways to set up the Network Camera over the
up the Network Camera behind a
to use
PPPoE.
6 - User's Manual
mount the lens to the Network
router.
The second way is to utilize a static
router.
The second way is to utilize a static
Camera:
connection.
Internet.
The first way is to set
IP.
Internet.
The first way is to set
IP.
The third way is
The third way is
Advertisement
Table of Contents
