Table of Contents
Advertisement
A green bar indicates that even though motions have been detected, the event has not been triggered
because the image variations still fall under the defined threshold.
If you want to configure other motion detection settings for day/night/schedule mode, please click Profile
to open the Motion Detection Profile Settings page as shown below. A total of three motion detection
windows can be configured on this page as well.
Please follow the steps beolw to set up a profile:
1. Create a new motion detection window.
2. Check Enable this profile.
3. Select the applicable mode: Day mode, Night mode, or Schedule mode. Please manually enter a time
range if you choose Schedule mode.
4. Click Save to enable the settings and click Close to exit the page.
This motion detection window will also be displayed on the Event Settings page. You can go to
Application > Event Settings > Trigger to choose it as a trigger source. Please refer to page 82 for
detailed information.
User's Manual - 77
Advertisement
Table of Contents
