I-Vmd Setting [I-Vmd] - Panasonic WV-CW504S Operating Instructions Manual

Step 4
Move the cursor to "DURATION TIME" and select a time for switching between color and black-and-white images from the following:
(default: 10 seconds)
2 sec. - 10 sec. - 30 sec. - 60 sec.
(S)
Step 5
Move the cursor to "BURST (BW)", and decide whether or not to provide a burst signal output in the black-and-white mode.
ON (default): Provides a burst signal output.
OFF: Does not provide any burst signal output.
Note:
• Images may not be displayed appropriately without burst signals when camera images are displayed in the black-and-white mode
depending on a monitor or VCR model to be used. In such a case, set the burst signal output to "ON".

9. i-VMD setting [i-VMD]

The intelligent motion detection function allows the camera to detect motion and appearance/disappearance of an object or interfer-
ence with the camera. Detection of motion and appearance/disappearance of an object or interference with the camera can be
announced by issuing an alarm signal or displaying a frame on the screen.
Important:
• The following circumstances may result in detection failure or false detection: Adjusting the detection area and sensitivity may
cause detection failure.
• Not enough difference in brightness between the background and the moving photographic subject, or significant changes in
brightness
• Dirt or water drops on the lens
• Insufficient brightness, for example, when shooting at night
• The subject is moving straight at the camera
• The subject is moving too fast or too slow
• The subject is too small or too large
• There are too many moving objects
• Light reflected through a window or from a road surface
• The camera is shaking
• Entry of outside light, such as sunlight or the headlights of a car
• Flickering fluorescent light
• Scene change detection may fail in the following cases:
• The lens is partially covered or covered with a transparent item
• The photographic subjects before and after changing the camera direction are similar
• False detection may occur for approx. 1 minute after turning on the power, after completing settings in the SETUP menu, or after
changing the camera view angle.
(L)
15