Buffalo AirStation NFINITI High Power WHR-300HP User Manual page 7

Chapter 1 Introduction
Diag LED Meaning
status
1
2 blinks * Flash ROM error
1
3 blinks * Ethernet (wired) LAN
error
1
4 blinks * Wireless LAN error
5 blinks IP address setting error
Continuously Updating the firmware
*2
blinking Saving settings
Initializing settings
*1 Unplug the AC adapter from the wall socket, wait for a few seconds, and then plug it again. If the
light still flashes, please contact technical support.
*2 Never unplug the AC adapter while the Diag LED is blinking continuously.
Status
Cannot read or write to the flash memory.
Ethernet LAN controller is malfunctioning.
Wireless LAN controller is malfunctioning.
Because the network addresses of both the Internet port (WAN
port) and the LAN port are the same, it is not possible to establish
communication. Change the LAN side IP address of this unit.
Updating the firmware.
Saving the settings.
Initializing the settings.
- 6 -