Supermicro Supero X8DAH+-F User Manual page 89

Clear BMC System Event Log
Select OK and press the <Enter> key to clear the BMC system log. Select Cancel
to keep the BMC System log. The options are OK and Cancel.
Caution: Any cleared information cannot be recovered. Make absolutely
sure that you no longer need any data stored in the log before clearing
the BMC Event Log.
Set LAN Configuration

Set this feature to configure the IPMI LAN adapter with a network address as shown
in the following graphics.
Channel Number - This feature displays the channel number for the SET LAN
Configuration command.
Channel Number Status - This feature displays the channel status for the
Channel Number selected above: "Channel Number is OK" or "Wrong Channel
Number".
IP Address Source
Select the source of the IP address for this system. If Static is selected, you will need
to know and manually enter the IP address of this machine. If DHCP is selected,
BIOS will search for a DHCP (Dynamic Host Configuration Protocol) server in the
network it is attached to, and request the next available IP address. The options
are DHCP and Static.
The following items are assigned IP addresses automatically if DHCP is selected
under IP Address Source above:
IP Address
Enter the IP address for this machine. This should be in decimal and in dotted quad
form (i.e., 192.168.10.253). The value of each three-digit number separated by dots
should not exceed 255 as shown in the screen below.
Subnet Mask
Subnet masks tell the network which subnet this machine belongs to. The value of
each three-digit number separated by dots should not exceed 255.
Gateway Address
This is the IP address of the gateway in the network that the system is connected to.
It's usually a router. If "Static" is selected, the subnet mask setting can be entered.
The value of each three-digit number separated by dots should not exceed 255.
4-23
Chapter 4: AMI BIOS