Replacing The Lamp Unit; Resetting The Lamp Runtime - Panasonic PT-LX30HU Operating Instructions Manual

Replacement

Replacing the Lamp unit

J
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the
z
lamp, the connector may be damaged.
1 ) Turn off the Power by following the procedure
in "Turning off the projector" (
Unplug the AC power cord. Wait at least 45
minutes and make sure the lamp unit and
surroundings are cool.
2 ) Use a Phillips screwdriver to loosen the
lamp cover fixing screw and remove the
lamp cover.
Remove the lamp cover by pulling it slowly toward
z
the direction of the arrow.
3 ) Use a Phillips screwdriver to loosen the
two lamp unit fixing screws until the
screws turn freely. Hold the used lamp unit
by its handles, and pull it gently from the
projector.
4 ) Insert the new lamp unit in correct direction.
Tighten the two lamp unit fixing screws
securely with a Phillips screwdriver.
5 ) Attach the lamp cover, and tighten the lamp
cover fixing screw securely with a Phillips
screwdriver.
Attach the lamp cover by pushing it slowly opposite
z
the direction of the arrow.

Resetting the Lamp Runtime

J
Be sure to reset the [Lamp runtime] after replacing the lamp. (
64
- ENGLISH
page 31).
Æ
page 57 " Lamp runtime reset")
Æ
Lamp cover
Lamp cover
fixing screw
Handles
Lamp unit
Lamp unit fixing screws