Turning Off The Projector - Panasonic PT-LX30HU Operating Instructions Manual

Turning Off the Projector

1 ) Press the < > button on the control panel or
the remote control, and Power off? appears on
the screen.
2 ) Press the < > button on the control panel or
the remote control again to turn off the projector.
The <STANDBY(R)/ON(G)> indicator starts to
blink red, and the cooling fans keep running.
At this time, you can unplug the AC power cord
even if the fans are still running.
3 ) When the projector has cooled down enough, the
<STANDBY(R)/ON(G)> indicator stops blinking
and you can turn on the projecto
Note
Do not put the projector in a case before the projector is
z
cooled enough.
STANDBY(R)/ON(G)>
While the <
z
the lamp is being cooled down and the projector cannot
be turned on. Wait until the <
indicator stops blinking to turn on the projector again.
The projector can be turned on after the <
z
ON(G)>
indicator turns red. The waiting time to restart
will be shortened when the normal power-off processing
for fan cooling is completed, compared with the time the
AC power cord is immediately unplugged after the power-
off.
Direct Power Off function
J
You can disconnect the power cord from the wall
outlet or turn off the breaker even during projection
without pressing the < > button.
Note
When using the Direct power Off function, you can
z
not restart the projector immediately after the power is
disconnected. If the external power supply is suddenly
cut off, the fans stop immediately. The lamp remains high
temperature and needs to be cooled.
When the lamp has been cooled by the direct power off
z
function, it sometimes takes longer than usual for the
lamp to light up again.
r.
indicator is blinking,
STANDBY(R)/ON(G)>
STANDBY(R)/
Powering ON/OFF
Power off? disappears after 4 seconds.
31
ENGLISH -