Using Remote Control; Installing And Removing Batteries; Setting Remote Control Id Numbers - Panasonic PT-CW230U Operating Instructions Manual

Projector operations

Hide thumbs Also See for PT-CW230U:

Table of Contents

Using Remote control

1 )

Open the cover

Remove the batteries in the reverse order of installation.

When you use the system with multiple projectors, you can operate each projector individually using single

remote control, if unique ID number is assigned to each projector.

After setting the ID number of the projector, set the same ID number to the remote control.

There are 2 different ID codes (Code 1 and Code 2), the initial ID number is [Code 1].

Setting the ID number

Press and hold both the MENU and IMAGE buttons together for 5 seconds or more. After changing the

code, make sure the remote control operates properly.

Note

For details, please refer to the [Remote control] of the [Setting] menu. (

This remote control is only for PT-CW230U and PT-CX200U. You cannot operate the other Panasonic projectors by using

this remote control.

- ENGLISH

2 )

Install batteries and close the cover

(Insert the – side first.)

page 57)

MENU button

IMAGE button

Table of Contents

Table of Contents

Pt-cx200u