Lexmark T656 Setup Manual page 31

IPDS Printer and Host Setup Guide PSF/AIX LAN Printing Using an Internal LAN Print Server
TCP/IP Settings
Parameter
Netmask
(Appropriate netmask for your network)
Gateway
(IP address of your IP gateway)
Enable DHCP
(On, if you use a DHCP server.)
(Off, if you set the IP address another way.)
Enable RARP
(On, if you use a RARP server.)
(Off, if you set the IP address another way.)
Enable BOOTP
(On, if you use a BOOTP server.)
(Off, if you set the IP address another way.)
Enable AutoIP
(Default is On. This is the recommended setting.)
WINS Server Address 157.184.100.20
(Address of your WINS Server)
DNS Server Address
(Address of your DNS Server)
8 Save/submit any changes and return to the Ready screen.
9 To verify the new print server settings, print a Network Setup Page. Using the control panel MENU/Menus,
select Reports > Network Setup Page. Note that the Network Job Timeout is identified as End-of-job
Timeout on this report.
Step 4 Select the IPDS Emulation, Bar Code Size, Host Resolution, and Fax Interrupt
Settings
It is important to select the correct emulation in the printer IPDS MENU before sending IPDS jobs.
Guidelines for Choosing the IPDS Emulation Setting
The IPDS Emulation, the BAR CODE and Host Resolution options are found in the printer control panel
under MENU/Menus > Option Card Menu > IPDS MENU > EMULATION.
1 "Resident" is the default setting. If you are replacing a printer that used a Native Emulation setting,
"Resident" is the recommended emulation.
2 If you are replacing a printer that used a 4028 Emulation setting, choose the "Resident" Emulation and
change the following settings:
a) Set Bar Code Size to "4028" under BARCODE > Bar Code Size.
Value
255.255.255.0
157.184.67.1
On or Off
On or Off
On or Off
On or Off
157.184.115.7
31