Lexmark T656 Setup Manual page 18

IPDS Printer and Host Setup Guide PSF/MVS LAN Printing Using the Standard Network Port or Internal Print Server
1 From a Ready state press the MENU button (printers) or touch
2 Use the navigation buttons or icons
3 Select Network/Ports.
TIp: To do this on printers, press the Select button
4 Now you will see a list of menus. Select the Standard Network menu.
5 Select Std Network Setup.
6 Select TCP/IP.
7 Use the navigation buttons or icons to scroll through the options. Check each of the following settings and
change them as needed to configure TCP/IP communication.
TCP/IP Settings
Parameter
Activate
(Printers: Must
cations. MFPs: not displayed.)
Address
(Address available from your network administrator)
Netmask
(Appropriate netmask for your network)
Gateway
(IP address of your IP gateway)
Enable DHCP
(On, if you use a DHCP server.)
(Off, if you set the IP address another way.)
Enable RARP
(On, if you use a RARP server.)
(Off, if you set the IP address another way.)
Enable BOOTP
(On, if you use a BOOTP server.)
(Off, if you set the IP address another way.)
Enable AutoIP
(Default is On. This is the recommended setting.)
WINS Server Address 157.184.100.20
(Address of your WINS Server)
DNS Server Address
(Address of your DNS Server)
to scroll to Network/Ports.
Value
On
be "On" to enable TCP/IP communi-
157.184.67.102
255.255.255.0
157.184.67.1
On or Off
On or Off
On or Off
On or Off
157.184.115.7
(Menus on MFPs).
; on MFPs just touch Network/Ports.
18