Phase 2 - Install Hp Drivers - HP Tc2110 - Server - 128 MB RAM Installation Manual

Chapter 6
2. Review the Server Settings. If you do not want the "SERVER" to
automatically load after reboot, Modify the "Load Server at reboot"
parameter to NO.
3. Go to the "Server SET Parameters" and Choose Edit. A window will pop-up
and the following should be added:
i. SET MINIMUM PACKET RECEIVE BUFFERS=2500
ii. SET MAXIMUM PACKET RECEIVE BUFFERS=12500
4. Press ESC, save the changes.
5. Scroll down to select Continue.
6. Review the regional settings and modify if necessary.
7. Review the mouse and video settings and modify if necessary.
8. Wait a few minutes while system files are copied from the CD-ROM.
PHASE 2 – Install HP Drivers
1. The installation program then detects your hardware and attempts to match
the drivers to the hardware.
2. If you have an IDE system, press Enter to continue. If you have a SCSI
model, you need to install the HP SCSI driver:
a. Scroll down to chose Modify and press Enter.
b. Scroll down to highlight the "Storage Adapters" item and press Enter.
c. The installation program displays the drivers detected: a SCSI driver and
a generic ATA/IDE/ATAPI Adapter driver (IDEATA.HAM). Press
Delete to remove the default SCSI driver. The only remaining driver
should be the IDEATA.HAM driver.
NOTE Do NOT remove the IDEATA driver because it is used by the
CD-ROM Drive.
d. Insert HP disk NW SCSI (created with the Startup CD) in the floppy
drive.
e. Press Insert to add a driver, then Insert again to add an unlisted driver.
f. Press F3 and specify the path: A: then press Enter.
48
Installing Novell NetWare 6.0 and Novell Small Business Suite 6.0