HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual page 48

Chapter 5
5. Follow the instructions in your NetWare documentation for installing a new
server.
6. After NetWare installs the DOS portion of the software, down and exit to DOS
from the server prompt.
7. Copy the <File Name>adpt160m.ham and adpt160m.ddi from the NetWare
directory of the Ultra3 Family Manager Set disk for NetWare to the
c:\server.312 directory.
8. Change directory to c:\server.312, and copy the nwpa_up.exe patch file to the
directory.
9. Run nwpa_up.exe. (This will create another file, 312ptd.exe. Answer Y to the
prompt to overwrite cdrom.nlm.)
10. Run 312ptd.exe.
11. Create the directory c:\server.312\cdsave.
12. Copy cdrom.nlm to c:\server.312\cdsave.
13. Execute the following command lines to swap the server's loader:
cd 312ptd\native\loader
lswap loader.exe \server.312\server.exe
cd \server.312
14. Create the startup.ncf file in the c:\server.312 directory using Edit or a text editor
with the following lines:
load c:\server.312\312ptd\native\start\npapatch
load c:\server.312\mmattrfx
load c:\server.312\nbi31x
load c:\server.312\adpt160m
Add any additional driver load lines for dual-channel or multiple-channel host
adapters.
15. Run server.exe.
16. Note the slot number detected for the HP Ultra3 SCSI host bus adapter.
The slot number can be added to the startup.ncf file, as described in
below, to automate driver load using the parameter slot=x, where x is the
detected slot number (for example, load c:\server.312\adpt160m slot=2).
17. Load Install. Create the NetWare partition, SYS volume, and mount the volume.
Complete the installation of the System and Public Files.
42
Novell NetWare Installation
Step 21