Removing And Replacing The Chassis Cover - HP T5720 - Compaq Thin Client Hardware Reference Manual

Removing and replacing the chassis cover

Å
Hardware Reference Guide
To install internal hardware, you must remove the chassis cover as
shown in the following procedures.
WARNING: Before removing the chassis cover, ensure that the thin
client is turned off and the power cord is disconnected from the electrical
outlet.
1. Remove the two screws that secure the cover to the chassis 1.
2. Slide the cover about 1/2-inch toward the back of the unit, and
then lift the cover off the chassis 2.
3. Disconnect the speaker cable 3 from the system board.
Removing the chassis cover and disconnecting the speaker
To replace the chassis cover, reverse the previous procedure.
www.hp.com
Hardware upgrades
2-3