Epson SureLab D3000 - Single Roll Operation Manual page 51

E
Rotate the flanges forward slowly to take up the slack in the paper.
Note:
Printing when the paper is sagging could decrease print quality and cause a paper jam. Make sure you take up the
slack in the paper.
F
If the paper type has changed, set the paper type on the Operation panel.
Each time you press the Paper type setting switch on the front roll paper feeder, the paper type changes and
the light flashes to indicate the current paper type.
Tip:
If you clear the cover open error by clicking OK on the Client PC, you cannot change the paper type. To change the
paper type, remove the paper from the Paper feed slot, reinsert it, and then try again.
Replacing Paper
51