Epson SureLab D3000 - Single Roll Operation Manual page 21

B
Select the printer you want to start from the Registered Printer List, and then click Pre-operation Check.
Tip:
O If the selected printer is already available, the Pre-operation Check button is unavailable.
O If the cable connected to the printer is disconnected, or the printer's Power switch is off, an error message is
displayed because connection is not possible. Check the contents of the message.
U "Errors and Solutions" on page 110
C
Perform the manual check items displayed on the screen. Click OK after completing the operations.
When you click OK, the printer automatically performs a Pre-operation Check. It takes about 4 to 5 minutes
to complete the Pre-operation Check.
Tip:
If the Printer PC does not shut down correctly for any reason such as a power failure, the Printer PC may not start
after performing a Pre-operation Check. If this happens, start the Printer PC manually, and then perform a
Pre-operation Check.
Starting up and Shutting down the Printer
21