Executing The Diagnostic Test - Toshiba Satellite A40 Maintenance Manual

3 Tests and Diagnostics
3. Select the test you want to execute and press Enter. When SYSTEM TEST is selected,
the following message will appear:
SYSTEM TEST
SUB-TEST
PASS COUNT : XXXXX
WRITE DATA : XX
ADDRESS
SUB-TEST MENU :
01 - ROM checksum
02 – Geyserville
03 -
04 - Fan ON/OFF
05 –
06 - Quick charge
07 - DMI read
08 - DMI write
09 - Thermister Check
99 - Exit to DIAGNOSTIC TEST MENU
NOTE: The menu displayed by your computer may be slightly different from the one
shown above.
4. Select the desired subtest number from the subtest menu and press Enter. The following
message will appear:
TEST LOOP : YES/NO
Selecting YES increases the pass counter by one, each time the test cycle ends and restarts
the test cycle.
Selecting NO returns to the subtest menu after the test is complete.
3-6
XXXXXXX
: XX
ERROR COUNT
READ DATA
: XXXXXX STATUS

3.2 Executing the Diagnostic Test

XXX DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C] : key stop
: XXXXX
: XX
: XXX
? ? ? ?
: Select items
Enter : Specify
Esc : Exit
Satellite A40 Maintenance Manual (960-458)