4 Replacement Procedures
Check the condition after mating.
*Check the condition of the concave portion of
the FPC and the outline of the connector.
*Insert the FPC to the end. There shall be no
out of position in
*Lock surely the connector.
Fit the pin and the hole.
Screw
Figure 4-147 Replacing 15.0 Inch Sharp fluorescent lamp (SXGA+) (19)
4-148
.
Fold the source board.
Poor mating: Failure
Fit the pin and the hole.
Screw tightening torque: 0.9kg cm
Fold the gate board.
4.26 Fluorescent lamp
Out-of-position in : F a i l u r e
Screw
Screw
(G)
Fit the pin and the hole.
Do not cover the
projection.
Screw
Satellite A40 Maintenance Manual (960-458)