Replacing The Mouse - Lenovo K100 Hardware Maintenance Manual

Replacing the mouse

connector
at either the front or rear of the computer.
4. Disconnect the failing keyboard cable from the computer and connect
the new keyboard cable to the same connector.
5. Refer to the "Completing the installation".
Attention
Do not remove the computer cover or attempt any repair before
reading the "Safety information" .
To replace the mouse:
1. Remove any media (diskettes, CDs, or tapes) from the drives, shut
down your operating system, and turn off all attached devices and the
computer.
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse.
Note: Your mouse might be connected to the standard mouse
connector
at either the front or rear of the computer.
4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse cable to the connector.
6. Refer to the "Completing the installation. "
at the rear of the computer or to a USB connector
at the rear of the computer or to a USB connector
Chapter 7. Replacing hardware
41