Security Options - Lenovo K100 Hardware Maintenance Manual

program".)
2. From the Setup Utility program menu, selet Security.
3. Select Change User Password and press Enter.
4. The password dialog box will be displayed. Type the new password, and
press Enter.
5. when prompted to confirm the password, type the password again. If
you type the password correctly, the password will be installed.
To delete a previously set user password, do the following :
Note: When prompted for a password, you must type your supervisor
password.
1. From the Setup Utility program menu, select Clear User Password and
press Enter.
2. A message will display that indicates the password has been disabled.
3. Press any key to contine.

Security Options

After a Supervisor Password is set, the Security Options can be displayed
below the Change User Password.
To set Security Options, do the following:
1. Start the Setup Utility program (See "Starting the Setup Utility
program".)
2. From the Setup Utility program menu, selet Security.
3. Set the Supervisor Password .
4. When the Security Options is displayed, Select Security Options.
5. Select Setup or Always and press Enter.
6. Return to the Setup Utility program menu and select Exit and then Save
changes and Exit.
Notes:
a. If you choose Setup of the Security Options, the Setup Utility
program does not display until you type your password. But you can
start other programs without the password.
b. If you choose Always of the Security Options, You can't start any
program until you type your password.
Chapter 5. Using the Setup Utility
19