Advertisement
Available languages
Available languages
Cycle time too short
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
Is the automatic
cycle ending early?
The load may not be contacting
the sensor strips. I.evel the dryer.
Change
the dryness
[eve[ setting
on Sensor Cycles.
Increasing or decreasing
the dryness
[eve[ will
change the amount
of drying
time in a cycle.
Lint on load
•
Is the lint screen clogged?
Clean
lint screen. Check for air movement.
Stains on load or drum
•
Was dryer fabric
softener
properly
used?
Add dryer fabric softener sheets at the beginning
of the cycle. Fabric softener
sheets added
to a partially
dried load can stain your garments.
I)rum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to
other clothing.
Loads are wrinkled
Was the load removed
from
dryer at the end of the cycle?
Select Custom
Refresh cycle to tumble
the load with water and heat to help smooth
out
wrinkles
from a load [eft in the dryer.
Was the dryer overloaded?
Dry smaller
loads that can tumble
freely. Smaller
loads yield
best results with
the Rapid
Refresh Small I.oad cycle.
Results may also vary depending
on fabric type. This cycle is
best for reducing
wrinkles
and odors from loads consisting
of wrinkle-free
cotton,
cotton
polyester
blends,
common
knits, and synthetics.
Odors
Have you recently been painting, staining,
or varnishing
in the area where
your dryer is
located?
If so, ventilate
the area. When
the odors or fumes are gone from the area, rewash
and dry
the clothing.
To remove
odors
left in garments
after wearing,
select the Rapid Refresh Small I_oad cycle
for small loads of two to four garments.
This cycle is best for reducing
wrinkles
and odors
from
loads consisting
of wrinkle-free
cotton,
cotton
polyester
blends
common
knits, and
synthetics.
Advertisement
