Advertisement
Available languages
Available languages
2.
Place drying
rack inside dryer drum, positioning
the back wire on the ledge of the inner
dryer back panel.
Push down on front edge of drying
rack to secure at the front of the
dryer.
B
I
A. Dryer rack front edge
B. Dryer back panel
3.
Put the wet items on top of the drying
rack. I.eave space between
the items so air can
reach all the surfaces.
NOTE:
I)o not allow
items to hang over the edge of the drying
rack.
I
4.
5.
6.
7.
Close the door.
Press the POWER/CANCEl.
button.
8.
Select a Timed
Dry cycle and temperature
(see following
chart).
Items containing
foam,
rubber, or plastic
must be dried
on a clothesline
or by using the Air Fluff temperature
setting.
You must select a time by pressing
TIME ADJUST + (plus) or - (minus).
Reset time as
needed to complete
drying.
Refer to the following
table.
Press START/PAUSE.
This chart shows examples
of items that can be rack dried and the suggested
cycle,
temperature
setting,
and drying
time. Actual
drying
time will depend
on the amount
of
moisture
items hold.
Rack Dry
Setting
Temp.
Time*
(minutes)
Wool
Sweaters
Timed Dry
I.ow
60
Block to shape and lay flat on the drying
rack.
Stuffed
toys or pillows
Timed Dry
I_ow
60
Cotton
or polyester
fiber filled
Rack Dry
Setting
Temp.
Time*
(minutes)
Timed Dry
Air Fluff
90
(no heat)
Sneakers or canvas shoes
Timed Dry
Air Fluff
90
(no heat)
*Reset time to complete
drying,
if needed.
DRYER CARE
Keep dryer area clear and free from items that would
obstruct
the flow of combustion
and
ventilation
air.
Explosion
Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion,
or fire.
Clean the lint screen before each load. The control
panel has an indicator
light to remind
you
to clean the lint screen before each load. A screen blocked
by lint can increase
drying time.
IMPORTANT:
•
I)o not run the dryer with the lint screen loose, damaged,
blocked
or missing.
Doing
so
can cause overheating
and damage
to both the dryer and fabrics.
•
If lint falls off the screen into the dryer during
removal,
check the exhaust
hood
and
remove
the lint.
Advertisement
