Setting Up The Wirelesshd Kit - RocketFish RF-WHD210 User Manual

Remote control
Note: Remote control design subject to change.
Item Description
1 SLEEP button -Press to put the WirelessHD receiver and transmitter into sleep
mode; or to "wake" them up from sleep mode if they do not automatically do so
on their own (this functionality varies by brand and model of connected
components). Be sure to point the remote toward the transmitter. Once the
transmitter wakes up, the receiver automatically wakes up as well.
2-5 HDMI 1-4 - Press to select the HDMI port for the signal source of your choice.
Note: Remove the plastic film from the remote control
before using it for the first time. Make sure you point
the remote control at the WirelessHD transmitter.
Plastic film

Setting up the WirelessHD Kit

Setup tips:
- The transmitter and receiver are pre-paired at the
factory.
- Test the placement of the transmitter and receiver for
a good signal prior to permanently mounting or
installing everything.
- For best performance and range, use the included
receiver mounting bracket to mount the receiver
vertically on the wall next to the TV (NOT behind the
TV) or upside-down on the ceiling next to the projector,
ensuring that the Rocketfish and WiHD logos can be
seen from the position in the room where the
transmitter will be located.
- Use only good quality high-speed HDMI cables for all
connections, such as Rocketfish brand cables. Poorly
constructed HDMI cables can negatively impact
performance and may not support all of the features
included with your connected source devices.
- Do not place the transmitter or receiver inside a
cabinet or other location where they will not have a
clear view of the room.
Refer to the following setup diagrams to
arrange your transmitter and receiver. For
best performance the transmitter and
receiver should face each other, with the
receiver mounted vertically to the wall next to
the TV (not behind the TV) or upside-down
on the ceiling next to the project, ensuring
that the Rocketfish and WiHD logos can be
seen from the position in the room where the
transmitter will be located.
Side view
32.8 ft. (10 m)
Transmitter
Top view
Transmitter
32.8 ft. (10 m)
82°
82°
16.4 ft. (5 m)
Receiver
Note: The transmitter and receiver must be located
within the same room. The wireless signal will not pass
through walls, floors, or ceilings.
16.4 ft. (5 m)
47°
Receiver
47°
16.4 ft. (5 m)
Floor
16.4 ft. (5 m)
RF-WHD210 5