Hunter 28672 Owners And Installation Manual page 4

Step 2 - Cut the Ceiling Hole
2-1 . Locate the site for the ceiling hole directly below the joist or support brace that
will hold the outlet box and fan .
2-2 . Cut a 4" diameter hole through the drywall or plaster of the ceiling . You will use
the hole to install the support brace and outlet box .
Step 3 - Install a Support Brace, If Necessary
Determine if there is a ceiling joist directly above the ceiling hole . If the joist is there,
determine if it is positioned to allow you to recess the outlet box a minimum of
1/16" into the ceiling . If NOT, install a support brace as follows:
3-1 . Attach a 2" x 4" support brace between two joists . Position it to allow you to
recess the bottom of the outlet box a minimum of 1/16" into the ceiling .
3-2 . Check the support brace to ensure it will support the full weight of the fan and
light kit .
Step 4 - Install the Outlet Box
4-1 . Obtain a UL-approved octagonal 4" x 1-1/2" outlet box, plus two #8 x 1-1/2"
wood screws and washers, available from any hardware store or electrical supply
house .
4-2 . Orient the outlet box so that both the inner and outer holes in the box align
with the joist or support brace .
4-3 . Drill pilot holes no larger than the minor diameter of the wood screws (5/64")
through the inner holes of the outlet box .
4-4 . Attach the outlet box directly to the support brace or joist with two #8 x 1-1/2"
wood screws and washers . Th e bottom of the outlet box must be recessed a
minimum of 1/16" into the ceiling .
Step 5 - Prepare the Wiring
5-1 . Make sure the circuit breakers to the fan supply line leads and associated wall
switch location are turned off . If you cannot lock the circuit breakers in the
off position, securely fasten a prominent warning device, such as a tag, to the
service panel .
5-2 . Thread the fan supply line through the outlet box so that the fan supply line
extends at least 6" beyond the box .
5-3 . Attach the fan supply line to the outlet box with an approved connector,
available at any hardware store or electrical supply house .
5-4 . Make certain the wiring meets all national and local standards and ANSI/NFPA
70 .
You have now successfully prepared your ceiling fan site . For instructions to install
your ceiling fan, go to your fan manual and continue with Section 2 • Installing the
Ceiling Plate.
Preparing the Fan Site (continued)
4
45068-01 • 05/19/10 • Hunter Fan Company
Steps 2 – 3
Step 4
Step 5
CAUTION: All wiring must be in
accordance with national and local
electrical codes and ANSI/NFPA 70 . If
you are unfamiliar with wiring, use a
qualified electrician .