Hunter 28672 Owners And Installation Manual page 13

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
7-6 . To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly .
Note: Both plug connectors are polarized and will only fit together
one way . Make sure the connectors are properly aligned before
connecting them . Incorrect connection could cause improper
operation and damage to the product .
7-7 . Place the lower switch housing assembly over the upper switch
housing . Align the side screw holes in the upper and lower switch
housings . Attach the lower switch housing to the upper switch
housing with three housing assembly screws .
Installing the Glass Bowl
7-8 . First install B10 candelabra bulbs (60 Watt Maximum)
into the sockets .
7-9 . Place the cover plate up against the glass
bowl . Align the holes in the cover plate
and glass bowl .
7-10 . Screw the finial onto the threaded rod end
until tight .
Note: In compliance with US federal
energy regulations, this ceiling fan
contains a device that restricts
its light output . Exceeding the
wattage limit marked on the MAX
wattage sticker affixed to the light
socket(s) may result in fire hazard
or improper operation . If lights
do not appear to be operating
properly, see the troubleshooting
section .
13
45068-01 • 05/19/10 • Hunter Fan Company
Steps 7-6 – 7-7
Lower Switch
Housing
Housing
Assembly Screw
Plug
Connector
for Light Bulbs
(60 Watt
Maximum)
Metal Disk
Metal Rod
Glass Bowl
Cover Plate
Finial