Mounting And Installation - Elation Design Spot 1400E Owner's Manual

7. MOUNTING AND INSTALLATION

Cautions:
For added protection mount the fixtures in areas outside walking paths, seating areas, or in
areas were unauthorized personnel might reach the fixture.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device's weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture.
Mounting
The Design Spot 1400E™ is fully operational in two different mounting positions, hanging
upside-down from a ceiling, or set on a flat level surface (see illustration on next page). Be
sure this fixture is kept at least 0.5m (1.5ft) away from any flammable materials (decoration
etc.). Always use and install the supplied safety cable as a safety measure to prevent
accidental damage and/or injury in the event the clamp fails.
©Elation Professional®
Caution!
Be sure a certified rigging technician has approved all installation
and rigging before attempting operation.
Warning!
Be sure to keep all flammable material at least 0.5m (1.5") away from
this fixture at all times.
Refer to regulations BGV C1 (formerly VBG 70) and DIN VDE0711-217
for proper installation in Europe to ensure proper installation. Only
qualified personnel should attempt installation.
14 Design Spot 1400E™
Design Spot 1400E™