Safety Information - Lenovo ThinkServer RD330 Safety Information Manual

Safety information

Important: The caution and danger statements in this document are labeled with numbers. Each number
identifies an English-language caution or danger statement that refers to translated versions of the caution
or danger statement in the Safety Information document. For example, if a danger statement is labeled
"Statement 1," translations for this danger statement are in the Safety Information document under
"Statement 1."
Ensure that you read and understand all caution and danger statements in this document before you perform
the procedures. Read and understand any additional safety information that is included with the server or
optional device before you install, remove, or replace the device.
Statement 1
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
• Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
• Connect all power cords to a properly wired and grounded electrical outlet.
• Connect to properly wired outlets any equipment that will be attached to this product.
• When possible, use one hand only to connect or disconnect signal cables.
• Never turn on any equipment when there is evidence of fire, water, or structural damage.
• Disconnect the attached power cords, telecommunications systems, networks, and modems before you
open the device covers, unless instructed otherwise in the installation and configuration procedures.
• Connect and disconnect cables as described in the following table when installing, moving, or opening
covers on this product or attached devices.
To connect:
1. Turn everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn devices ON.
© Copyright Lenovo 2011, 2012
To disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
1